Ironing Board Cover

My last few blogs have been about the Sew Expo in Puyallup. My main splurge there was at the Bo-Nash booth, where I purchased an IronSlide Ironing Board Cover and an IronSlide Iron Shoe. Stephanie did a nice job promoting the products and I decided to give them a go.

20160225_104303

I have a “European” ironing board which is 18″ wide and 49″ long, and always have difficulty finding the appropriate size of ironing board cover. I purchased the Giant IronSlide cover which is 65″ x 29″. It is self adhesive and you simply peel off the paper backing and stick it down. I removed my old cover and extracted the padding from it to use again, and then added the silver self-adhesive IronSlide cover. I cut around the ironing board leaving a margin to tuck in at the sides and cut slits in it to miter around the edges. It was a little tricky and the adhesive is extremely sticky, but I managed to install it on my own. Having a second pair of hands would definitely have made the job easier. The ironing board looks pretty slick now and so far, I’m liking it.

20160309_125440 20160309_132746

20160309_133533 20160309_141115

The IronSlide cover is made from luninex which reflects 300% more heat than regular cotton covers, so this in theory cuts the ironing time in half and both sides are ironed at once. If it has creases in it after installation, these will iron out. I didn’t have any problem with that and mine is nice and smooth. The cover is very stable and doesn’t move around at all.

In my next blog, I will show you the IronSlide Iron Show.

Leave a Reply

Your email address will not be published. Required fields are marked *